 Accessories |
||
| Test Blocks- These blocks are used to check the accuracy of your Hardness Tester, available for the hardness tests. Calibrated at our standardizing laboratory, test blocks are available in a wide range of hardness values and can be calibrated at any of the standard loads. | ||
Vickers Indenter - Both indenters are diamond ground. The Vickers is in the form of a square based pyramid with an angle of 136 o between faces. |
||
Clamping Device- Standard vise used for securing a wide range of specimens for easy and accurate testing. |
||
| Rockwell Accessories | ||
| They are made of hardened steel and are offered in many scales and ranges. Used for determining the accuracy of your hardness tester. | ||
Steel and Brass test blocks- Of brass or hardened steel. Used for determining the accuracy of your hardness tester. |
||
Test block calibration set- Provide complete control not only in the accuracy of the tester checked, but also in the accuracy and condition of the penetrators. |
||
| Diamond Indentors- Used for testing hardened steels. Available in "C", "N", "A" and "C&N" scales. We offer special types of indenters to fill your needs. |  |
|
| Anvils- We carry a large line of anvils. Available in many different sizes so it makes it easier on you to test your material. We carry eyeball anvils for testing tapered parts. We carry Vee anvils for testing large, round and cylindrical parts. We are able to make up any type of anvil for your special requirements. |  |
|